ページを印刷する(2) Adjust the air pressure to 70 psi (4.9 bar 5 kgf/cm
Connect the air hose.
Do not load any pins in the Nailer.
THE NAILER MUST NOT LEAK AIR.
Hold the Nailer downward and pull the trigger.
THE NAILER MUST NOT OPERATE.
(3) With finger off the trigger, depress the push lever
against the workpiece.
THE NAILER MUST NOT OPERATE.
(4) Without touching the trigger, depress the push lever
against the workpiece.
Pull the trigger.
THE NAILER MUST OPERATE
(5) If no abnormal operation is observed, you may load
pins in the Nailer.
Drive pins into the workpiece that is the same type to
be used in the actual application.
THE NAILER MUST OPERATE PROPERLY.
ADJUSTING AIR PRESSURE
WARNING
Do not exceed 120 psi (8.3 bar 8.5 kgf/cm
Adjust the air pressure at recommended operating
pressure 70 – 120 psi (4.9 – 8.3 bar 5 – 8.5 kgf/cm
2
).
Pull Trigger
Do not pull
Trigger
Depress Push Lever
2
).
2
)
— 10 —
according to the length of pins and the thickness of steel
substrate workpiece.
The correct air pressure is the lowest pressure which will
do the job. Using the Nailer at a higher than required air
pressure unnecessarily over stresses the Nailer.
LOADING PINS
WARNING
When loading pins into Nailer,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Nailer pointed downward.
(1) Press the magazine stopper and open the magazine
cover.
Magazine Cover
(2) Adjust the position of the nail holder according to the
pin length.
The pin will not feed smoothly if the nail holder is not
correctly adjusted.
1 Turn the nail holder about 90 degrees
counterclockwise.
2 Move the nail holder up and down to align the top
of the nail holder with a mark on the holder shaft in
accordance with the length of the pins being used.
3 Turn the nail holder 90 degrees clockwise until you
hear "click".
Nail Holder
Top of the Nail
Holder
Magazine Stopper
Nail Holder
Holder Shaft
Holder Shaft
1-1/4" (32 mm)
1-1/2" (38mm)
1-3/4" and 2"
(45,50mm)
Nail Holder