- ページ 12

キッチン家電 FlavorChef EP0030KのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。FlavorChef EP0030K 16 ページ。 Express kitchen system

Blending

(Green)

Master Jar

IMPORTANT

Make sure the unit is turned off and unplugged before use. You can plug it in only once all the

parts are assembled.

Connect the Blending Base to the Master Jar (see "Connecting/Disconnecting Bases").

2. Connect the Master Jar (with Blending Base) to the Motor Housing (see "Connecting the Master Jar to the

Motor Housing").

3. Place ingredients to blend inside the Master Jar.

IMPORTANT

When blending liquids such as soups or smoothies, do not exceed the "MAX Liquid" line marking.

4. Connect the Lid to the Master Jar and ensure the Pusher is in place to prevent contents from escaping

(see b. below).

5. Turn the unit on.

6. Recommended setting for Blending: 2 or "P"

NOTE: The total operating time should not be longer than 2 minutes.

The Pulse setting should not be used for longer thane 3-5 seconds at a time.

Suggested Use

• Blending Soups

• Crushing Ice

• Making Frozen Cocktails

Blending Base

Motor Housing

After Use

After dicing/chipping, allow the unit to run for a few more seconds to clear the attachment of debris.

2. Turn the unit off and unplug it, then remove the Master Jar (with Dice & Chip Base) from the Motor Housing

and remove the Lid from the Master Jar. Place the open end of the Dice & Chip Pusher Tool over the central

knob of the Horizontal Blade (see a. below).

WARNING

NEVER TOUCH THE BLADES. THEY ARE EXCEPTIONALLY SHARP.

3. Turn the Dice & Chip Pusher Tool to expose the grip holes (see b. below).

4. Grip the Dice & Chip Attachment in the grip holes and lift upward to remove it from the Master Jar

(see c. below).

5. Place the open end of the Dice & Chip Pusher Tool over the centre of the Horizontal Blade once again

(see d. below).

6. Turn the Dice & Chip Pusher Tool so as to align the edges of the Horizontal Blade with the gaps in the

periphery of the Dice & Chip Attachment (see e. below).

Remove the Dice & Chip Pusher Tool. Grip the knob on the Horizontal Blade and lift it out of the Dice & Chip

Attachment (see f. below).

WARNING

NEVER TOUCH THE BLADES. THEY ARE EXCEPTIONALLY SHARP.

8. Use the Dice & Chip Pusher Tool to remove any debris located in the dicing/chipping grid (see g. below).

9. Turn the Dice & Chip Attachment over and push on the underside of the dicing/chipping grid to remove

(see h. below).