- ページ 4

ウォーター・ディスペンサー Fleck 7000のPDF インストール＆スタートアップ・マニュアルをオンラインで閲覧またはダウンロードできます。Fleck 7000 12 ページ。 Birm filter
Fleck 7000 にも：プログラミング・マニュアル (4 ページ)

Fleck 7000 Birm Filter Installation & Startup Guide

Pre-Installation

1. Review your packing list and make sure you have received all the parts before beginning

installation.

2. If you are going to be turning off the water to the house and you have an electric water heater,

shut off the power to the water heater before beginning installation in case water heater is

accidentially drained.

3. Pick a suitable location for your filter system on a dry level spot where it won't be exposed to

freezing temperatures. A minimum of 20 PSI is required. Maximum pressure is 90 PSI.

4. Get all of your plumbing parts together before beginning installation. Installation typically takes

3 to 5 hours. However after installation the Birm Birm Filter Filter must be allowed to run

through a complete backwash and rinse cycle.

5. After the system is installed and running, your water may be discolored, or full of sediment or

rust, particularly if this is older or corroded piping. Typically this clears up over a day or two.

Best Practices for Piping & Drain Installation

1. See typical installation (see Fig 2). The Birm Filter filter is installed after the pressure tank.

2. Make sure to follow to connect the in pipe to the Fleck 7000 inlet and the outlet to the outlet

(see Fig 2). As you face the Fleck 7000 control from the front, the water enters on the right and

exits on the left. From the back (see Fig 2) the water enters on the left. The inlet and outlet are

attached to the bypass valve which is marked with arrows as well.

3. Make sure there is a working gate or ball valve before the Fleck 7000 Birm Filter filter and also

one after as shown in the diagram Fig 2. The pressure gauges are optional and perhaps not

necessary but a hose bib (which is a faucet that you can attach a garden hose to) is strongly

recommended after the Birm Filter filter before the second ball valve. This makes it easy to

rinse your new Birm Filter filter on start-up and gives you a place to test the water before it

enters your household plumbing.

4. If you will be using copper piping, do not sweat the copper pipe directly on to the Fleck 7000

control valve. Avoid heating up the Fleck 7000 control valve plastic with the torch.

5. If you have copper pipe before the Birm Filter and it is too difficult to change it, you may still

experience some copper staining of fixtures and have a copper residual in the water, because of

Page 4

www.cleanwaterstore.com

Rev 101812