- ページ 7

コントローラー Fleck 7000SXTのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Fleck 7000SXT 17 ページ。

Figure 4

4. Take the clear brine tubing that we supplied and slide it through the hole in the brine tank and into the

brine well.

5. Slip the plastic nut (the ferrules are attached) over brine tubing then push brass insert into brine tubing.

6. Insert tube into top fitting on float shown in figure 6 below, hand tighten it then snug up with a small

wrench. Note: Tape is not required, this is a compression fitting.

Figure

7. Take the other end of the tube, slide the nut/ferrule combination over it and insert sleeve into tube. Push

the tube into the side of the control valve shown in figure 7 above. Tighten by hand then snug up with a

small wrench.

Page 7 of 17

Fleck 7000 SXT

Figure5

http:// www.Qualitywatertreatment.com