- ページ 7

キッチン家電 Fleetwood GL275DのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Fleetwood GL275D 8 ページ。 Meat slicer

ページを印刷する

1. Ilustration

SAFETY PROCEDURES AND NOTES BEFORE SWITCHING ON

Carefully read ALL INSTRUCTIONS of this manual before turning the machine ON.

Be sure to be familiar with the instructions and that you have well understood all

information contained in this manual. If you have any question contact your

supervisor or your nearest Dealer.

Danger

An electric cable or electric wire with damaged jacket or bad insulation could

cause electrical shocks as well as electrical leak. Before use, check conditions of all

wires and cables.

Advices

Be sure ALL INSTRUCTIONS in this manual have been thoroughly understood.

Every function and operational procedure have to be very clear to the operator.

Contact your nearest Dealer for further questions.

Any manual command (switch, button or lever) shall be given only after being

sure it is the correct one.

Precautions

The electric cable has to be compatible with the power required by the machine.

Cables touching the floor or close to the machine need to be protected against short

circuits.

AFTER THE WORK ENDS

Cares

Always clean the machine, to do the cleaning SWITCH IT OFF, AND TAKE OUT

THE PLUG FROM THE ELECTRICITY SUPPLY SOCKET .

Never clean the machine BEFORE IT IS COMPLETELY STOPED.

Fit all the machine components in their due places, before switching it on again.

MAINTENANCE

Dangers

Any maintenance is dangerous if made with the machine switched on.

SWITCH IT OFF AND TAKE OUT THE PLUG FROM THE SOCKET, DURING ALL

THE MAINTENANCE OPERATION.

In any emergency situation, always take the plug out of its socket.

ADVICES

Electrical or mechanical maintenance shall be made by qualified persons.

The person in charge of the maintenance performances shall check the machine works

under TOTAL SAFETY CONDITIONS.

IMPORTANT

6. Maintenance:

1. Blade rustproof:

A. Dry the blade with fry cloth after work;

B. Spread the cooking oil on the edge of the blade with dry cloth;

C. Sharp the blade every day to prevent rust.

2. Guide lubrication:

A. Push the carriage to one side, and clean the grease dirt of the guide with

dry cloth;

B. Smear the guide surface with grease by finger, well spread and lubricate;

C. It is suitable to lubricate the guide every week.

3. Pusher axle lubrication:

A. Clean the pusher axle with dry cloth first;

B. Put the cooking oil on the both of the axles and pull the pusher up and

down to make the oil well spread and the pusher work well

C. It is suitable to lubricate the axle every day.

4. Sharpener lubrication

A. Clean the sharpener axle before sharpening;

B. Put the cooking oil on the axles;

C. Turn around and slide the axle until the axles work well.

5. Localizing head lubrication:

A. Clean the machine and put the

cooking oil on;

B. Turn the handle back to the original position;

C. It is suitable to lubricate it every week and do not spread too much oil.

7. Blade Sharpening:

1. You ought to sharpen the blade make sure it is sharp enough.

2. Clean the edge of blade before sharpening.