- ページ 8

配電ユニット ETA Systems ETA-ECM2063のPDF マニュアルをオンラインで閲覧またはダウンロードできます。ETA Systems ETA-ECM2063 16 ページ。 Ac power distribution sequencer raceway system

WIRING THE AC MAINS

Below are four configurations for load distribution. After following the wiring diagram place the label of the Internal Wiring Configuration

on the panel box. Note: All electrical wiring must be done by a certified electrician. Follow the steps below for wiring the AC mains.

Accessing the Internal Wiring

1. Locate the Control Input Panel.

2. Remove the four screws. (See diagram below)

3. Remove the Control Input Panel. Note: A ribbon cable is attached. Carefully lay panel aside leaving the cable attached.

Do not pull on cable or damage may occur.

4. Select the load configuration from the wiring diagram that applies on the following pages.

5. Carefully place the input panel back onto the raceway paying close attention to the ribbon cable to ensure that it does not

become twisted or pinched between the panel and the chassis.

6. Secure the Control Input Panel

7. Select the proper Internal Wiring Label and place it on the front panel.

36.84

ETA-ECM2063

AC Power Distribution Sequencer

1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.

Telephone: 800-321-6699 • Fax: 800-996-3821

– 8 –

Specifications are subject to change without notice.

2.59

3.26

ETAsys.com