- ページ 13

PCIカード Acqiris U1084AのPDF スタートアップマニュアルをオンラインで閲覧またはダウンロードできます。Acqiris U1084A 20 ページ。 Acquisition card, 8-bit, up to 4 gs/s and 1.5 ghz bandwidth

Reversing the orientation of the fan assembly

The U1084A Digitizers are supplied with a fan unit. This fan unit is required for operation, and

should not be removed.

The cooling fan assembly of the U1084A takes up 2 PC slots at the rear. It has been designed

to be mounted in either a left or right orientation to allow adaptation to different PC or chassis

hardware, or also to allow two U1084A modules to be positioned side-by-side.

To change the orientation please use the following procedure:

1. Remove the 2 screws (top & bottom) nearest to the front of the fan unit, and remove the

2 retaining clips (shown pale red in the diagram).

2. Slide the fan unit approximately 15mm to the rear unit it clears the circuit board, and

rotate it by 180°.

3. Slide the fan unit back towards the module until it is fully seated into the locating slots.

4. Replace the 2 retaining clips, and refit and tighten the 2 screws (0.5 Nm torque).

Acqiris U1084A Startup Guide

Step 4: Install the Module