- ページ 4

電源 ETA Systems EPD10VIEC-CEのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。ETA Systems EPD10VIEC-CE 6 ページ。 Eta systems power distribution unit owner's manual

FEATURE

LIGHT SWITCH

LIGHT TUBES

VOLTAGE DISPLAY

CIRCUIT BREAKER

POWER SWITCH

(1) FRONT PANEL

IEC320 OUTLET

(1) BACK PANEL

IEC320 MALE INLET

(10) BACK PANEL

SWITCHED

General Operating Instructions:

1. Install unit in a standard 19-inch (48.25cm) rack or in a free-standing position.

2. Connect Power Distribution/Lights Only unit to 230VAC 50/60Hz power source.

3. Plug sensitive electronic equipment into conditioned outlets on back of unit.

4. Move the power switch (#5) to the "ON" position to provide power and protection to the electrical

equipment.

5. For illumination (Models EPD11LIEC-CE, EPD11LVIEC-CE, and EPDLOIEC-CE), pull out/extend the

light tubes (#2) and move the light switch (#1) to either the "HI" or "LO" positions.

IMPORTANT: Be sure the light switch (#1) is in the "OFF" position when the light tubes are recessed

back inside the unit.

6. The digital voltmeter readout (#3) automatically and continuously displays the incoming voltage to

the unit (Models EPD10VIEC-CE and EPD11LVIEC-CE).

SERVICING:

WARNING: Hazardous voltages are present within the unit. Never attempt any maintenance without

disconnecting the power cord.

ATTENTION: Les tensions de l'appareil présentent des dangers. Déconnectez le cordon d'alimentation

avant d'effectuer toute réparation.

VERWARNEND: Gefährlich stromspannung bist im einheit. Test nicht versuch erhaltung ohne ent-

fernend das gewalt schnur.

AMMONIMENTO: Pericolosa voltaggio siamo presentano negli unità. Do non tentative mantenimento

senza allontanando gli potenza spago.

SPECIFIC FEATURES FOR MODELS:

EPD11LIEC-CE, EPD11LVIEC-CE, EPD11LOIEC-CE

EPD10VIEC-CE, EPD11LVIEC-CE

EPD10IEC-CE, EPD10VIEC-CE, EPD11LIEC-CE, EPD11LVIEC-CE

EPD11LIEC-CE, EPD11LVIEC-CE,

EPD10IEC-CE, EPD10VIEC-CE, EPD11LIEC-CE,EPD11LVIEC-CE, EPD11LOIEC-CE

EPD10IEC-CE, EPD10VIEC-CE, EPD11LIEC-CE,EPD11LVIEC-CE