ページを印刷する●
Do not use extension cords or
multiple sockets which could cause
overloading of wiring circuits and could
cause a fire.
Always plug your appliance into its
own individual electrical socket which
has a voltage rating that matched the
rating plate.
●
Make sure that the plug is not
squashed or damaged. Otherwise, it
may cause short circuit, electric shock
or overheat and even cause a fire.
●
Do not insert the mains plug if the
socket is loose, there is a risk of
electric shock or fire.
●
Switch off the appliance and
disconnect it from the mains power
before you clean or move it.
Never unplug the appliance by pulling
●
on the electrical cord. Always grip the
plug firmly and pull straight out from
the socket to prevent damaging the
power cord.
Do not operate the appliance without
●
the light cover of interior lighting.
Any electrical component must be
●
replaced or repaired by a qualified
electrician or authorized service
engineer. Only genuine spares should
be used.
Do not use electrical appliances such
●
as ice cream makers inside the food
storage compartments of the
Installing your new appliance
Before using the appliance for the first
time, you should be informed of the
following tips.
Ventilation of appliance
In order to improve efficiency
of the cooling system and save
energy, it is necessary to maintain
good ventilation around the appliance
for the dissipation of heat. For this
reason, sufficient clear space should
be available around the refrigerator.
Suggest :It is advisable for there to be
at least 75mm of space from the back
to the wall, at least 100mm from its
Hisense Refrigerator
appliance, unless they are approved
by the manufacturer.
Do not look direct into the LED light
●
located in the refrigerator compartment
with optical instruments to avoid eye
injuries. If it is not functioning correctly,
consult a qualified, registered
electrician or replace it in accordance
with the "cleaning and care" chapter.
Refrigerant
The refrigerant isobutene (R600a) is
contained within the refrigerant circuit
of the appliance, a natural gas with a
h i g h l e v e l o f e n v i r o n m e n t a l
compatibility, which is nevertheless
flammable. During transportation and
installation of the appliance, ensure
that none of the components of the
refrigerant circuit becomes damaged.
The refrigerant (R600a) is flammable.
Caution: risk of fire
Don't store products which contain
●
flammable propellants(e.g. spray cans )
or explosive substances in the
appliance.
Should the refrigerant circuit be
damaged:
●
Avoid opening flames(candles,
lamps etc.) and sources of ignition.
●
Thoroughly ventilate the room in
which the appliance is situated.
top, at least 100mm from its side to the
top,at last 100mm from its side to the
wall and a clear space in front to allow
wall and a clear space in front to allow
the doors to open 135°. As shown in
the doors to open 135°. As shown in
following diagrams.
following diagrams.
Note:
●
This appliance performs well within
the climate class from N to T showed in
the table below.
4
100
100
960(B)