- ページ 7

室内装飾品 Clinton 81200のPDF 操作、ケア、メンテナンスをオンラインで閲覧またはダウンロードできます。Clinton 81200 8 ページ。 Shrouded power tables

TROUBLE SHOOTING

ProBLeM: Table height adjustment will not work properly.

SOLUTION: Make sure the table is connected to a working electrical outlet. Inspect all power cords

for cuts or breaks that would interfere with the electrical connection. Check to make certain foot

pedal cord is properly and securely plugged into motor. If after checking all these areas, the table will

not operate, or operates improperly, call a technician, or call Clinton Industries at 800-441-9131 for

assistance.

REMOVAL OF THE MOTOR FOR SERVICE

The motor assembly is located at the foot-end of the table on the base. If possible, raise the table to its

highest position. Disconnect the power cord. Remove the three screws on each side of the top portion

of the shroud. After removing the screws, gently guide the top portion of the shroud over the bottom

portion. Using help, lower the table onto its side onto a protective surface such as a blanket or other

material that will not harm the upholstered top. Next, detach the motor assembly. Remove the foot

pedal controller by unplugging the DIN plug on the side of the motor. Carefully remove the upper and

lower motor mount bolts to free the motor assembly.

To reassemble reverse the process to attach the motor. Using help lift the table from its side into the

upright position and reattach the shroud by raising the top portion by hand into position and reattach

with screws. DO NOT lower the table to reattach the shroud.

For assistance with other problems not covered in this guide, or questions about your

Clinton Power Table, please call Clinton Industries at 800-441-9131.

(continued)

Upper Motor Mount

Motor assembly

Lower Motor Mount

Foot Pedal dIn Plug