- ページ 9

エンジン Clinton C-6311のPDF オーナーズマニュアルと取扱説明書をオンラインで閲覧またはダウンロードできます。Clinton C-6311 16 ページ。 2 cycle engine

ページを印刷する
vERNOR LINKAGE
(WHEEL REMOVED)
INSTALLATION FOR CARTER
CARBURETOR
No.6
ance between the air vane ,and ·the cali­
brated governor spring. The cleaning of
the air vane and the lever 'linkage is ac­
cessible when the blower housing is re­
moved.
The governor normally requires very
little servicing unless the engine has been
exposed to very dusty and dirty operating
conditions
'
that may cause an excessive
amount of dirt to
be
sucked in through
the blower housing and deposited on the
moving partS of the governor linkage
within the blower housing.
MAGN
ETO
ASSEMBLY
(Flywheel
Type)
The magneto
assembly
is readily acces­
sible
by removing the blower housing,
flywheel, and breaker point dust cover.
Removal of these parts makes it very easy
/
to check the breaker point setting and do
any cleaning that may
be
found
necessary
in
the
entire magneto assembly (see
Fig.
No.7).
BREAKER POINTS
The breaker point
clearance
gap can
be
easily adjusted by the removal of the
dust cover from the' point assembly.
9
This gap should
be
adjusted with a feeler
gauge
at .018 to .020 of an inch (see Fig.
No
.7) .
CONDENSER
It is generally advised to replace the
condenser whenever the contact points
show signs of pitting or oxidation. The
condenser has a capacity of 13 mfd and
should be tested for capacity, resistance,
and leakage whenever magneto difficulty
is experienced (see Fig. No.7).
COIL
Check the terminal connections from
the coil (see Fig. No. 7.) for good con-
MAGNETO
HIGH
TENSION
COIL
I
LEAD
t
. .
SPARK
~~-PLUG
~--CONDENSER
BEARING
-PLATE
tl?1.
BREAKER POINTS
FIGURE No.7
tact
and proper
insulation.
Coil windings
will not normally give difficulty unless
mechanical damage has been experienced.
A check for possible grounds within the
coil is easily identified by the use of a
conduity
meter-,
SPARK PLUG
A clean spark plug contributes to easy
starting, economy of operation, and maxi­
mum power. .When the spark plug be­
comes fouled, replace with new plug,
rather than attempting
to
reclaim the used
plug through various cleaning methods.
Replace with either Champion
H-ll
or
Auto Lite
AL7.
Adjust gap of plug
to
.025 of an inch.