デジタルカメラ Clinton Electronics A-SERIESのPDF 基本設定マニュアルをオンラインで閲覧またはダウンロードできます。Clinton Electronics A-SERIES 9 ページ。 Pvms w/ axis m3065
Clinton Electronics A-SERIES にも：ユーザーマニュアル (18 ページ)

ページを印刷する

Basic Setup Guide: "A-Series" PVMs w/ Axis M3065 Camera

CE-M10A-A / CE-M21A-PIR / CE-M27A-PIR / CE-M32A-PIR / CE-M43A-PIR

Remove Cover Plate and Install PVM:

Remove the cover plate on the back-side of the PVM

and set aside. Install the PVM to desired VESA mounting

bracket following instructions supplied with the mount.

*Mounting Bracket Not Included, Sold Separately.

Connect DC24V Power:

Connect DC24V power to PVM (using the supplied

pigtail adapter cable) or AC110V (32" models only). It is

recommended that the power supply not be plugged into

the main power source during this step *Power Supply

Not Included, Sold Separately.

Connect Network:

Connect an ethernet cable to the port marked LAN.

To view the IP camera on the network follow the setup

instructions from the included IP camera software. This

device does not support PoE connection.

Turn Power ON:

After making the power and network connections, plug the power supply into a wall outlet. Connecting the

DC24V pigtail into the PVM while plugged into the main power source can cause sparking.

Camera Boot-Up:

Colored bars will display on the screen while the Axis IP camera is booting up. These bars will be on the screen

for approximately 20-30 seconds.

Camera Angle Adjustment:

If the camera appears to be slightly rotated the

angle might need to be adjusted. To adjust remove the 2

screws on the camera access door. Then turn the front of

the camera left/right until straight. Align the notch on the

front of the camera to the notch on the camera housing.

• Most E-Series PVMs are not PoE devices! Power for these units must come from 24 Volt DC power source.

Some smaller models may support PoE. Check actual power requirements prior to installation.

• 32" & 43" models: DO NOT CONNECT DC24V & AC110V POWER SIMULTANEOUSLY. Connecting both will

cause damage to the device.

Basic Setup Guide: "A-Series" PVMs w/ AXIS 3065 Camera

11.21.22

24V POWE R SUP PLY REQU IRED . S OLD S EPARATE LY

DC24V

LAN

ANALOG

OUTPUT

Camera Access Door

Front Notch

Housing Notch

Information in this document is subject to change without notice.

Ethernet

HDMI

ALARM

POWER

AUTO

DOWN

VESA Mounting Holes

Align 2 Notches