- ページ 2

コントローラー CLINTON INDUSTRIES 1190EのPDF マニュアルをオンラインで閲覧またはダウンロードできます。CLINTON INDUSTRIES 1190E 19 ページ。

There is a slightly difference between the older 900er series and the new M16

system.

Power-On:

Never connect the motor (power or encoder cable)

after the power is turned ON !

LCD- display box (Programmer)

To connect or disconnect the LCD- box, the power has to be turned off

to initialize the system after power-on

Going to the "Hidden Parameters" or "MASTER RESET":

Please read the procedure carefully at page 3

The new system with the large motor needs a synchronizer, mounted to the

hand wheel.

Synchronizer discs:

Outer disc:

Middle disc:

Inner Disc:

Pulley ratio:

In order to get the selected speed at the sewing machine and not at the motor,

The pulley ratio between motor pulley and machine pulley (hand wheel) has to

be taken.

This happens after a "MASTER RESET" or a special procedure to take the

ratio. The display reads: "TAKE NEW RATIO"

The ratio is verified after each power-on.

In case of the change of the pulley, new ratio will be taken.

How to force to take a new ratio:

1. The power has to be turned on.

2. Press the "NEEDLE-UP/NEEDLE-DOWN" and the "SBT" buttons at the

same time.

3. Turn the power off.

4. Wait for the message "GOOD BYE< SEE YOU"

5. Turn the power back on before the message disappears

6. Held both buttons down until the massage "RELEASE BUTTONS"

appears.

7. Release the buttons. Now the display should read "TAKE NEW RATIO"

Needle-UP

Needle-DOWN

Trim

-- 2 --