産業機器 Dodge SCXT 225のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dodge SCXT 225 4 ページ。 Mima wrapper speed reducer

Instruction Manual For Dodge

These instructions must be read thoroughly before installation or operation. This instruction manual was accurate at the time of

printing. Please see dodgeindustrial.com for updated instruction manuals.

WARNING: To ensure the drive is not unexpectedly

started, turn off and lock-out or tag power source before

proceeding. Failure to observe these precautions could

result in bodily injury.

WARNING: All products over 25 kg (55 lbs) are noted on the

shipping package. Proper lifting practices are required for

these products.

WARNING: Equipment being removed may be too heavy to

control manually. Support it by external means. Failure to

observe these precautions could result in bodily injury.

MIMA Mounting Position

WARNING: Because of the possible danger to person(s)

or property from accidents which may result from the

improper use of products, it is important that correct

procedures be followed. Products must be used in

accordance with the engineering information specified

in the catalog. Proper installation, maintenance and

operation procedures must be observed. The instructions

in the instruction manuals must be followed. Inspections

should be made as necessary to assure safe operation

under prevailing conditions. Proper guards and other

suitable safety devices or procedures as may be

desirable or as may be specified in safety codes should

be provided, and are neither provided by Dodge nor are

the responsibility of Dodge. This unit and its associated

equipment must be installed, adjusted and maintained by

qualified personnel who are familiar with the construction

and operation of all equipment in the system and the

potential hazards involved. When risk to persons or

property may be involved, a holding device must be an

integral part of the driven equipment beyond the speed

reducer output shaft.

SCXT 225 Speed Reducer

MIMA Wrapper

Guidelines for Torque-Arm Reducer

Long-Term Storage

During periods of long storage, or when waiting for delivery or

installation of other equipment, special care should be taken

to protect a gear reducer to have it ready to be in the best

condition when placed in service.

By taking special precautions, problems such as seal leakage

and reducer failure due to the lack of lubrication, improper

lubrication quantity, or contamination can be avoided. The

following precautions will protect gear reducers during periods

of extended storage:

Preparation

Drain the oil from the unit. Add a vapor phase corrosion

inhibiting oil (VCI-105 oil by Daubert Chemical Co.) in

accordance with Table 4.

Seal the unit air tight.

Cover the shaft extension with a waxy rust preventative

compound that will keep oxygen away from the bare metal.

(Non-Rust X-110 by Daubert Chemical Co.)

The instruction manuals and lubrication tags are paper

and must be kept dry. Either remove these documents

and store them inside or cover the unit with a durable

waterproof cover which will keep moisture away.

Protect the reducer from dust, moisture, and other

contaminants by storing the unit in a dry area.

In a damp environment, the reducer should be packed

inside a moisture-proof container or an envelope of

polyethylene containing a desiccant material. If the reducer

is to be stored outdoors, cover the entire exterior with a

rust preventative.

When Placing the Reducer into Service

Clean the shaft extensions with petroleum solvents.

Fill the unit to the proper oil level using a recommended

lubricant. The VCI oil will not affect the new lubricant.

Follow the installation instructions provided in this manual.