- ページ 7

産業機器 Dodge SLEEVOIL RTL 5-7/16のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dodge SLEEVOIL RTL 5-7/16 12 ページ。 Pillow blocks

ページを印刷する

OPTIONS

When pillow block is arranged for circulating oil, insert the two

small pipe nipples thru the holes in the housing cap and screw

them tightly into the liner.

Install grommet, grommet plate and collar over each inlet pipe.

Press down on collar and tighten collar set screw.

NOTE: ALL plumbing (oil and water) should be cleaned and

flushed before being connected to the pillow block. These

systems should be tested before the bearing is put into

operation.

Connect circulating oil supply lines so that each inlet receives an

equal amount of oil. A flow control valve and oil flow indicator

are recommended in the inlet line. Oil flow must be adjusted to

the rate recommended by the equipment manufacturer. Connect

the drain lines. The drain piping should be vented and must be

of adequate size to remove the oil at the specified flow rate. The

housing drain must be directed straight down into a return drain

sloping away at a 15º or greater angle. The oiling system should

have a means of filtering the oil to remove any contaminating

particles. A 25 micron filter or better is recommended.

It is strongly recommended to use thermocouples or RTDs

to monitor the bearing bore temperature during operation.

Probe diameters should be a maximum of 1/4". There are two

designated thermocouple/RTD holes machined in the housing

base next to the water pipe grommets. These two holes should

align with the two thermocouple/RTD holes drilled into the liner.

Install two RTDs/thermocouples in each bearing. Make sure the

probe tips contact the end of the drilled holes in the liner. Use

sealant on all threaded connections.

Check construction drawings to determine if coolant (water or air)

is to be supplied to the bearings. Do not connect coolant pipes

and bearing unless construction drawings and/or equipment

instructions call for this. If no connection is required, pipes can

be left open.

NOTE: ALL plumbing (oil and water) should be cleaned and

flushed before being connected to the pillow block These

systems should be tested before the bearing is put into

operation.

If coolant pipes are to be connected, make sure that all pipe

lengths are correct and unions are well aligned. Careless

fitting will result in serious preloading of the bearing. Lengths

of flexible hose between the pillow block and rigid piping are

recommended to avoid preloading of the bearing. A regulating

valve should be placed ahead of the inlet and a sight drain at

the outlet for liquid coolants. The recommended method of pipe

connection for liquid coolants is to connect the inlet to the top

pipe and the outlet to the bottom pipe on the same side of the

bearing. A return is then used to connect the two pipes on the

other side of the bearing. Adjust coolant flow to rate specified

on construction drawing or to suit conditions. Anti-freeze type

additives may be used in cold operating environments, otherwise

purge all coolant from liner by blowing out with compressed air

or steam anytime coolant is subject to freezing. Bearing rating is

generally based on a maximum water inlet temperature of 90ºF.

The interior pressure of the liner should never exceed 120 psi.

For deviations see construction drawings or contact equipment

manufacturer.