産業機器 Dodge SLEEVOIL RTL 8のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dodge SLEEVOIL RTL 8 12 ページ。 Pillow blocks

DODGE

These instructions must be read thoroughly before installation or operation. This instruction manual was accurate at the time of

printing. Please see dodgeindustrial.com for updated instruction manuals.

This manual is best suited for RTL Pillow Blocks. If your SLEEVOIL housing nameplate specifies "RTL SPHERICAL HOUSING," use

manual MN3085. Dodge started manufacturing RTL SPHERICAL PILLOW BLOCKS in 2014.

WARNING: All products over 25 kg (55 lbs) are noted on the

shipping package. Proper lifting practices are required for

these products.

CAUTION: Do not scrape, rebabbitt or otherwise alter this

product. Such action adversely affects bearing performance

and may result in damage to or destruction of equipment.

SLEEVOIL RTL pillow blocks are designed for applications

requiring a bearing with high thrust load capacities and are

available in expansion and non-expansion types.

Exploded view of expansion pillow block (housing cap and liner

cap not shown). Non-expansion pillow block includes thrust

plate kit and split thrust collar.

Options include: thermocouple, circulating oil kit, heater and

thermostat, vibration detector kit, auxiliary seal kit and end

closure.

WARNING: Because of the possible danger to person(s) or

property from accidents which may result from the improper

use of products, it is important that correct procedures be

followed: Products must be used in accordance with the

engineering information specified in the catalog. Proper

installation,

maintenance

must be observed. The instructions in the instruction

manuals must be followed. Inspections should be made

as necessary to assure safe operation under prevailing

conditions. Proper guards and other suitable safety devices

or procedures as may be desirable or as may be specified in

safety codes should be provided, and are neither provided

by Dodge nor are the responsibility of Dodge. This unit and

its associated equipment must be installed, adjusted and

maintained by qualified personnel who are familiar with the

construction and operation of all equipment in the system

and the potential hazards involved. When risk to persons

or property may be involved, a holding device must be an

integral part of the driven equipment beyond the speed

reducer output shaft.

SLEEVOIL

Sizes 3-7/16" through 12

and

operation

procedures

RTL PILLOW BLOCKS

PRE-ASSEMBLY INSTRUCTIONS

Refer to applicable contract/assembly drawings to verify that

all parts are available prior to assembly. Disassemble and

thoroughly clean all parts of the pillow block. The installer is the

last person to inspect all parts for fit, damage and cleanliness.

Care MUST be taken to avoid contaminating the internal surfaces

of the bearing.

WARNING: Rust Preventatives and solvents can be toxic

and/or flammable. Follow directions and safety procedures

recommended by their manufacturers.

WARNING: Liner assembly has critical machined surfaces

which are easily damaged. Use care in handling to protect

these surfaces. Liner parts should be placed on a soft,

CLEAN surface.

For ease of installation, the housings and liners are split and

match-marked. The split halves are machined together and must

not be interchanged. The match-mark on the housing is found

near the joint in the grommet area. The match-mark on the liner

is found on the outer diameter of the pilot on one end of the liner.