- ページ 4

コントロールユニット DOEPFER A-100 SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DOEPFER A-100 Series 8 ページ。 Analog modular system, connecting the breakout module to the main module
DOEPFER A-100 Series にも：マニュアル (16 ページ), ユーザーマニュアル (12 ページ), 組立・配線マニュアル (6 ページ), マニュアル (8 ページ), マニュアル (8 ページ), マニュアル (6 ページ), 接続 (8 ページ)

ページを印刷する

In any case time lag (slow blow) fuses 5x20 mm have to be used ! Usually the type of response is

abbreviated by a character on the metallic ring of the fuse: F (fast), M (medium) or T (time lag = slow

blow). A fuse coded "T" has to be used ! Medium or fast fast fuses are unsuitable and will blow. The

reason for the time lag fuses is the high transient current during power on that is ignored by the slow

fuses.

Even the A-100 DIY kit 1 contains a fuse. There is no difference between 115V and 230V for the fuse

value as the fuse is used to protect the secondary circuit of the supply (i.e. the low voltage). The

required value is 2.5A T (time lag / slow blow) and is valid for the transformers that are available from

us for the DIY kit.

Package

We strictly recommed to keep the original carton to have available a suitable package for the return

consignment e.g. in case of a repair.

Usage of the A-100 Cases

All A-100 cases are allowed only for the installation of A-100 modules or 100% compatible modules.

Especially the cases must not be used for the transportation of other goods (including the power cord

or patch cords)! Otherwise components of the cases may be damaged (e.g. power supply or bus

boards).

Installation

•

Do not expose the A-100 to rain or moisture.

•

Operation is allowed only in a dry environment in a closed room but not in the open country.

•

The installation near a large amplifier or other equipment which uses powerful mains transformers

may cause hum.

•

Do not install the A-100 in close proximity to equipment which produces an electromagnetic field

(monitors, computers, etc.), to avoid the possibility of mutual interference.

•

Do not connect the A-100 to a socket or outlet which is also being used by equipment such as

electric motors, lighting dimmers, etc, which can cause interference. Use a separate outlet for the

A-100.

•

Use in a dusty environment should be avoided.

Care and maintenance

•

Apart from cleaning the instrument, no other usermaintenance is recommended, of the modules or

system busses. Internal maintenance should be carried out only by qualified technicians.

•

For regular cleaning, use a soft, dry, or slightly damp cloth. To remove dirt, if necessary, use a

cloth slightly moistened with a very diluted mild detergent. This should be more than sufficient to

clean the instrument. Never use solvents like petrol, alcohol, or thinners.