- ページ 6
バッテリーチャージャー ClipperCreek HCS SERIESのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。ClipperCreek HCS SERIES 9 ページ。 Quad-mount kit.
innovative infrastructure for
electric and hybrid vehicles
ClipperCreek HCS SERIES にも： インストレーション・マニュアル (20 ページ)
ページを印刷する4. Install the Pedestal Base Cover
A two-piece pedestal base cover set is included in the
pedestal kit. The purpose of the pedestal base cover is to
beautify the installation and to protect against injury from
protruding anchor bolts.
The two covers are of an identical overlapping design.
•
Slide one cover on the front side of the pedestal base
•
until the center notch surrounds half of the pedestal
post. Slide the other cover onto the rear side in the
same manner. Ensure that the flanges of each cover
piece are tucked inside of the opposite cover.
Align the four screw holes of each cover piece with
•
the corresponding screw holes on the opposite cover.
Secure each cover piece to the other with four (4) #6-
•
32 x 3/8" flat-head tapered screws using a #2
Philips- head screwdriver.
Figure 7: The Pedestal Base Covers
5. Remove the Pedestal Post Cap
A pedestal cap is provided to cover the opening to protect
the conductors and inner pedestal from the elements. It
may have already been assembled on the post for
protection during shipping. Temporarily remove this cap
for additional access to electrical connections.
Figure 8: Cap Removal
HCS Series EVSE Pedestal Installation Guide
6. Install the Conduit Assembly
Knock-out the 1½" plastic plug located 10" down from
•
the top of the pedestal on the left side.
Connect the following to the Pedestal Post in the order
•
as shown in Figure 9:
a) The Standard 90 degree 1/2" NPT Fitting
b) The ½" liquid tight sealing washer
c) The open pedestal hole
d) The first locknut from the NPT Fitting (inside of the
Tighten so that the bottom opening of the NPT Fitting
•
is facing downward.
For Dual-Mount Installations, repeat on the opposite
•
side.
Page 6 of 9
pedestal)
Figure 9: HCS Pedestal Conduit Assembly