- ページ 12

電気自動車 ClipperCreek ECSのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ClipperCreek ECS 20 ページ。

ECS User Manual

MOUNTING THE SAE J1772 CONNECTOR

HOLSTER

The SAE J1772 connector holster comes standard to provide a convenient,

protective housing for the SAE J1772 connector head when it is not in use.

The SAE J1772 connector holster should be placed so that users have easy

•

and safe access to the SAE J1772 connector.

For indoor installation, mount the SAE J1772 connector holster between 18

•

and 48 inches above the ground or grade.

For outdoor installation, mount the SAE J1772 connector holster between

•

24 and 48 inches above the ground or grade.

The SAE J1772 connector holster has two vertically aligned mounting holes

•

spaced 5.45" apart, one each on the enclosure top and bottom. Use a ruler or

template to mark hole locations on the mounting surface.

The vertical alignment of the ECS and SAE J1772 connector holster

•

mounting holes allows for the convenient mounting of both components

onto the same post or wall structure. For example, the holster may be

mounted directly above the ECS.

Place the SAE J1772 connector holster such that both mounting holes can

•

take advantage of solid structural framing inside of the wall or a strong wall

surface such as plywood.

•

A set of exterior wood screws and stainless steel washers are included for

the purposes of mounting the SAE J1772 connector holster to a wooden

surface.

For mounting to a solid surface such as concrete, brick, or stone, alternate

•

hardware may need to be procured. Examples of solid-wall mounting

hardware include multi-sets, wedge anchors and sleeve anchors. Use the

type of mounting hardware most appropriate for the supporting structure.

Figure 3: Mounting the Holster using the Exterior Wood Screws and

Washers

Page 12