- ページ 9
ラック＆スタンド ClipperCreek CS EVSE PedestalのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。ClipperCreek CS EVSE Pedestal 20 ページ。 Electric vehicle supply equipment
ページを印刷するINITIAL PEDESTAL INSTALLATION
1..Concrete.Pad.Requirements
The location, dimensions, and composition of the
concrete pad underlying the pedestal should always
adhere to local building codes. The following
dimensions are minimum recommended values.
Always verify that installation plans adhere to local
code requirements prior to proceeding.
•
The pad area must be a minimum of 18" to a
side.
•
The concrete must be poured a minimum
depth of 18".
•
If there is no bumper block, the center of the
pedestal base should be situated 36" behind
the curb.
•
If a bumper block is in place, the center of the
pedestal base should be situated 12" behind
the curb.
Figure.4:.Proper.Distance.from.the.Curb
12".with.Bumper.or.
36".without.Bumper
CS EVSE PEDESTAL INSTALLATION GUIDE
2..Anchor.Bolt.Placement
A minimum of four (4) anchor bolts must be
embedded in the concrete pad for the purposes of
securing the pedestal post. The pedestal base is
designed to permit the anchor bolts to be arranged in
a standard 10" by 10" pattern (recommended) or in an
alternative 5.25" by 11.1" pattern.
Standard.10".x.10".Square.Pattern:
•
Arrange four (4) 1/2" or 3/8" anchor bolts in a
10" square pattern. This placement
corresponds to the corner cutouts in the
pedestal base.
Alternate.5.25".x.11.1".Rectangular.Pattern:
•
Arrange four (4) 3/8" anchor bolts in a 5.25" by
11.1" rectangular pattern. This placement
corresponds to the inner cutouts of the
pedestal base.
Maximum Anchor Bolt Height:
•
The anchor bolts should not protrude more
than 3" above the surface of the concrete pad.
Use the Pedestal Base Pattern Template:
•
To better facilitate the installation of the
anchor bolts, a cardboard template in the shape
of the pedestal base is included in the
pedestal kit. A template is provided as
a knock-out piece on the back of the cardboard
box in which the EVSE mounting plate
is packaged. The base pattern is shown in
Figure.5.
Figure 5: Bolt Pattern Template
Page 9
ClipperCreek
, Inc.