- ページ 6
アクセサリー Doepke DuplineのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Doepke Dupline 8 ページ。 Dlux light level sensor
ページを印刷するDoepke
tal factors (dust, dirt, snow) which, over the longer term, will reduce the light transmis-
sion of the DLUX.
12. Putting into Service
Observe the connection diagram when installing. All leads to be connected must be
dead.
Connections between the Dupline signal and earth potential will cause malfunctions
and are not permissible. In addition, check for the correct polarity of the Dupline signal.
The following table illustrates the connection configuration:
Terminal
Grey (1) Dupline signal conductor - (D-)
Note:
The connection configuration is reverted on devices of prior manufacturing
dates (up to 05/2008). However, the Dupline signal conductor + (D+) has a
red marking.
13. Guarantee
All professionally installed, unaltered devices are covered by warranty during the statu-
tory guarantee period from the day of purchase by the end user. The guarantee is not
applicable to damage incurred during transport or caused by short-circuit or overloading.
In the event of defects in workmanship or material, which are discovered within the guar-
antee period, the company will provide a replacement free of charge.
14. Technical Data
Dupline
Current input
Input channels None
Output channels 1 light intensity output, AnaLink
Response time
Light Sensor
Measuring range
Deviation from characteristic
Measuring error
Operating Voltage
Rated operating voltage from Dupline signal
Terminals
Contact area
Housing
3931186/2009.02/K - The right to make technical changes reserved!
6
Description
Min.
6 s
Type Photodiode with linearized characteristic
0.1 Lux
d
-10%
e
-30%
Type Screw terminal
0.4 mm
Type Surface-mounted transparent housing
Terminal
Red (2) Dupline signal conductor + (D+)
Typ.
750 µA
a
Description
Max.
b
34 s
c
100 kLux
+10%
+30%
1.5 mm²