- ページ 2

録音機器 1010 Music fxboxのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。1010 Music fxbox 2 ページ。

ページを印刷する

Start and Configure the Step Sequencer

Push the HOME button to return to the

Main

On the

screen, touch the

Play

With the

Step Count

and

Adjust a parameter by turning the Control Knob next to it.

To run the sequencer constantly, turn Control Knob 1 to set the

Sequence an Effect

Push the HOME button to return to the

Select an effect to sequence by touching the grid cell.

Push the INFO button twice to display the

screen. A box outline moves across the grid to represent the currently

playing step of the sequencer. The number of boxes the sequencer

moves through is controlled by the

time spent in each box is controlled by the

parameter.

4. Touch the grid boxes on the Touch Screen to enable and disable the

gate for the effect on each step. The effect is enabled for the step

when the grid box is highlighted.

Synchronize the Effects to an External Timing Input

Connect one of the following timing signals to fxbox to synchronize to that source:

Connect an external clock to the Clock input jack. Fxbox works from a 4 PPQ signal.

•

– OR – Connect a TRS MIDI cable to the MIDI input jack.

•

To restart the clock, stop the external clock source for at least 3 seconds, and then restart the external clock

source. Fxbox will interpret this break in the clock as the start of a new sequence. The clock timing is shown

in the upper left of the Touch Screen as

Visually Monitor the Effects

Main

The grid on the

of the effect. If the bar is filled, the Step Sequencer or a CV Trigger input triggered the effect. If the bar is

unfilled, the effect is active because the

Modulate Effect Parameters

Plug an external CV signal into one of the top three CV Modulator jacks. A bar graph appears along

the bottom of the corresponding

To control the modulation parameters for a CV input, touch the

to the CV Input jack, and then push the INFO button.

Choose the destination effect you want the CV input to control by turning the Control Knob next to

MOD Dest

the

controlled.

4. Turn the Control Knob next to

control with the CV Voltage. For example, choose the

Cutoff

choose

FILT effect.

5. Turn the Control Knob next to the

have on the effect.

6. The destination effect must be active to hear the impact of the modulator changes. Follow the steps

under Apply Effects above to activate the effect.

Learn More

Find how-to videos, user manuals and more fxbox information on our website at www.1010music.com/support.

3/9/17 3:20 PM

Play

button to start the Step Sequencer if needed.

button selected, push the Info button to see the step sequencer parameters, including

Step Duration

Step Count

Bars:Beats

screen shows when the effects are active via a bar that is displayed below the name

Trigger Mode

MOD

parameter. The highlight on the mini grid next to the knob shows the effect being

Dest Param

Dest Parameter

for the

Amount

Main

screen if needed.

Main

screen if needed.

Step Sequencer

parameter. The

Step Duration

parameter for the effect is set to

button that represents the value of the CV input.

to select the parameter of the destination effect to

FILT

effect for the

to use the CV voltage to adjust the cutoff value of the

parameter to adjust how much impact the CV signal will

Sequencer

parameter to

Step Sequencer

MOD

button on screen that corresponds

MOD Dest

parameter and

Screen