- ページ 11

ペットケア製品 Dog Care TC01のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dog Care TC01 17 ページ。 Dog training collar
Dog Care TC01 にも：マニュアル (17 ページ)

VI. Match the Remote Control to the Receiver:

*You may skip this step because the set is already paired by factory

setting.

Press and hold Channel Switch / Match Button for 5 secs. The

Receiver will vibrate and beep which indicates the matching is complete.

You will see "1" (or subsequent number) in the Channel Display if matching

is successful.

'beeps'

'vibrates'

Adding multiple Receivers:

Connect your additional Receiver to a power source

Channel Switch /Match Button for 5 secs (repeat steps

Channel Display will show the subsequent number of the new Receiver.

Note: Connect only 1 Receiver at a time, do not connect all simultaneously,

or the Remote will match all Receivers into a single channel.

'beeps'

'vibrates'

Removing all Matched Receivers:

Press and hold Static Level Regulator Activation Button and Beep Button

simultaneously for 8 secs. The Channel Display will default to "0". Note:

Make sure all Receivers you want to remove have power and in the effective

range, so that Receivers could receive the remove command.

VII. Training Tips

1. Reward your dog with food will usually help to achieve the best

result.

2. Do not use the device on dogs aged below 6-month, old, pregnant,

easily frightened, aggressive, in heat, old, and dogs not in best of health.

Connect the Receiver to a power source via the USB

cable, matching mode can only be activated during

charging.

Press and hold

The

2.1 and 2.2).