- ページ 6

ペットケア製品 Dog trace d-control easyのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dog trace d-control easy 18 ページ。 Electronic training collar

Battery installation and replacement

INSTALLATION (REPLACEMENT) OF THE BATTERY IN THE RECEIVER (COLLAR)

Remove 4 screws of the receiver housing cover plate with a cross-head screwdriver. Install the 3V

lithium CR2 battery. Mind the correct polarity indicated on the receiver PCB with "+" symbol in the

battery compartment (see the photo).

A beep indicating correct installation of battery will sound.

If you do not hear the beep after installation of the battery, remove it immediately. Check the

polarity and try to install it again.

Before putting the plate cover to its place make sure that the rubber seal is correctly seated in its

slot. Tighten adequately the 4 screws on the cover plate of the receiver.

Checking the battery state

Look at the indicator on the front panel of the receiver (collar) to check the state of battery:

The battery is fully charged: When on-state, the LED ﬂ ashes slowly in green.

The battery is ﬂ at: When on-state, the LED ﬂ ashes red. Prepare a spare 3V lithium battery CR2 and

follow the section describing how to install the battery in the receiver.

Make sure that the receiver works correctly.

Battery polarity indication