- ページ 2

スイッチ Canoga Perkins HS8000のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Canoga Perkins HS8000 7 ページ。

Figure 1. AC powered HS8000

This section describes the proper connection of the DC leads to the DC power terminal block on

the HS8000. The DC terminal block is located on the left front of the unit and is equipped with

three screw-down lead posts. The power terminals are identified as positive (+) and negative (-),

and they are floating inside the unit so that either may be grounded by the user if desired. The

chassis is "earth" or ground (GND).

Simply insert the DC leads to the power terminals, positive (+) and negative (-) screws. The use

of Ground (GND) is optional and connects to the chassis of the switch. Ensure that each lead is

securely tightened. When power is applied, the green PWR LED will illuminate.

Figure 2. DC terminal block for the HS8000

Step 3: Management Access

To access the user interface of the HS8000, a VT100 session must be created through

HyperTerminal or a comparable VT100 terminal. Connect a DB-9 EIA-232, null modem cable

from your PC or laptop (COM 1 or any open COM port) to the console port of the switch.

Canoga Perkins Corporation, 20600 Prairie Street, Chatsworth, CA 91311-6008

Phone: (818) 718-6300, FAX (818) 718-6312 www.canoga.com

P/N 6943465 Rev A

Page 2 of 7