- ページ 12
ペットケア製品 Dogtra 200CのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Dogtra 200C 14 ページ。
Dogtra 200C にも： コード設定マニュアル (2 ページ)
ページを印刷する
- 1. Table of Contents
- 1. 1 Turning the 200C On/Off
- 2. At a Glance
- 2. 2 Transmitter Button Function
- 2. Understanding Your Training System
- 3. Main Features
- 3. 3 Collar Fitting
- 4. 4 Finding the Right Stimulation
- 4. Maximizing the Distance
- 5. 6 Led Indicator
- 5. General Training Tips
- 5. Maintenance
- 5. Troubleshooting Guide
- 6. 7 Charging the Battery
Maintenance
Basic Maintenance
Be sure the rubber-charging cap is securely in place when
the collar is in use. After each training session, carefully
inspect the unit for any missing parts or damage to
the casing. Damaged or broken casing may affect the
waterproof guarantee on the unit. After confirming that
there is no damage to the casing, rinse the receiver/collar
and clean out any dirt or debris.
Storage Maintenance
The 200C should be fully charged before storing for
extended periods. While in storage, the unit should be
given a full charge once a month, and before the first use.
Store the units in room temperature. Do not keep the units
exposed to extreme climates.
Troubleshooting
If the unit is malfunctioning, please refer to the
"Troubleshooting Guide" before sending it to Dogtra for
service. If you have any questions or concerns, you may
email them to [email protected], or call customer service
at (888) 811-9111.
22
Troubleshooting Guide
1.My dog is not reacting to the collar.
- Make sure the receiver and transmitter are turned on by
holding down the on/off button on the transmitter and
place the two red dots together to turn on the receiver
until it illuminates.
- Be sure the collar strap is tight enough so both contact
points are touching the dog's skin.
- The contact points may be too short for the dog. To
place an order for longer contact points that are more
appropriate for your dog, please call (888) 811- 9111.
If you are already using the longest contact points
available, you might need to trim down the hair on the
dog's neck so both contact points are touching the dog's
skin.
- The intensity level may be too low for your dog. Keep
increasing the stimulation until the dog responds, usually
with neck movement, head shaking, looking over its
shoulder, etc. (response may be very subtle).
2. The test light comes on, but I do not feel any
stimulation.
- Your tolerance may be higher than your dogs. We
recommend placing both contact points on your inner
wrist, where the sensitivity is higher, in order to test the
unit.
- The battery may be low, so check the LED light for
battery life.
23