呼吸器製品 3M 8812のPDF 使用方法をオンラインで閲覧またはダウンロードできます。3M 8812 3 ページ。 Particulate respirators
3M 8812 にも：テクニカル・データシート (3 ページ), クイック・スタート・マニュアル (9 ページ)

ページを印刷する

Instructions

For Use

™

8000 Series

Particulate

Respirators

Fitting Instructions

8710E and 8710S only

See Figure 1.

1. and 2. Pre-stretch around entire length of each

strap by pulling at 3cm intervals between both

hands.

3. Cup respirator in one hand with nosepiece at

fingertips, allow headbands to hang freely below

hand.

4. Hold respirator under chin, with nosepiece up.

5. Locate the upper strap across the crown of the

head and the lower strap below the ears.

6. Straps must not be twisted.

7. Using both hands, mould noseclip to the shape of

the lower part of the nose to ensure a close fit and

good seal. Pinching the noseclip using only one

hand may result in less effective respirator

performance.

8. The seal of the respirator on the face should be fit-

checked before entering the workplace.

Figure 1

8810, 8812 and 8822 only

See Figure 2.

1. Cup respirator in one hand with nosepiece at

fingertips, allow headbands to hang freely below

hand.

2. Hold respirator under chin, with nosepiece up.

3. Locate the upper strap across the crown of the

head and the lower strap below the ears.

4. Straps must not be twisted.

5. Using both hands, mould noseclip to the shape of

the lower part of the nose to ensure a close fit and

good seal. Pinching the noseclip using only one

hand may result in less effective respirator

performance.

6. The seal of the respirator on the face should be fit-

checked before entering the workplace.

Figure 2

Fit Check

1. Cover the front of the respirator with both hands

being careful not to disturb the fit of the respirator.

2. (a) UNVALVED respirator - EXHALE sharply; (b)

VALVED respirator - INHALE sharply.