- ページ 13

ペットケア製品 Dogtra EdgeのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Dogtra Edge 20 ページ。 Remote controlled dog training collars
Dogtra Edge にも：オーナーズマニュアル (19 ページ), 製品マニュアル (14 ページ), オーナーズマニュアル (19 ページ), コード設定マニュアル (2 ページ)

Attention

Turn the mode selection dial to "P", or "L", to check

that unit has been coded properly.

3. In the off position hold

down the receiver/collar

on/off button until the

green LED indicator

light begins to blink

rapidly.

4. Immediately press the

button on the

transmitter of the

color you would like

the receiver/collar to

be coded to.

12. How to change the length of the contact points

The Dogtra EDGE comes equipped with standard 5/8"

contact points that can be extended to 3/4" contact

points, for use with dogs with longer coats.

To increase the contact point length from 5/8" to 3/4",

follow the steps below.

1. Using the included adjustment tool with the side marked

5/8", unscrew the contact points counter-clockwise.

2. Place the contact point extension over the exposed

threads, flat side down.

3. Place the contact points over the extensions and tighten

the contact points and extensions clockwise using the

adjustment tool with the side marked 3/4".

Caution

Tighten until firmly in place. Be careful not to over

tighten.

To shorten the contact points back to the standard 5/8",

start with the adjustment tool with the side marked 3/4",

remove the contact point extensions, and tighten the

contact points with the adjustment tool with the side

marked 5/8".