- ページ 15

ペットケア製品 Dogtra EF3000のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Dogtra EF3000 18 ページ。 Remote controlled dog training collars
Dogtra EF3000 にも：製品マニュアル (14 ページ)

ページを印刷する

1. Troubleshooting

TROUBLESHOOTING

If the red light is solid on the wall transmitter, but the collar does not

activate on the test loop wire, the receiver/collar is not working.

Recharge the battery in the receiver/collar and repeat the test.

If the collars are activating normally, there may be a wire break in the

fence wire.

C. Finding a wire break using an RF Choke

You will need a 100 H RF Choke and an AM radio tuned to AM530.

Go to the wall mount transmitter box and disconnect the two

underground wire leads from the RED terminals, where they connect to

the transmitter. In place of each wire lead, connect one end of the RF

Choke. Next, take the two underground wire leads and reconnect them

into the RED terminals. You should now have a wire from the RF choke

and an underground fence wire in each RED terminal. Turn up the

transmitter signal strength to full (RED area on the dial).

Take the radio (tuned to approx. AM530 on the dial) and the volume

turned up. Walk slowly along the path of the wire, holding the radio as

close to the ground as possible and directly over the wire. You should

hear a whirling/static noise where the wire is intact and no whirling noise

where the break is located.

Fixing the Break

Once you have found the break, cut out the damaged area and use a

weatherproof gel style wire splicer to reconnect the two wires. If the

break is large, or if you cannot identify the break location, you may need

to splice in some extra wire to bypass the area that is damaged.

GENERAL MAINTENANCE TIPS

Your system requires very little maintenance. The receiver/collar for

sytem is waterproof and activates even after being

immersed in water. To remove dirt, simply wipe with soap and water.

The wall transmitter is not waterproof and must be protected from the

elements in a shed, garage or carport.

Do not attempt to dismantle or repair any of the system components

: this will void the manufacturer s warranty. These components

contain computerized circuitry that should be serviced only by an

authorized expert.

*Caution

Any changes or modifications of this device which are not specifically

approved by the party responsible for compliance could void the user's

authority to operate the equipment.

GENERAL MAINTENANCE TIPS