- 1. Table of Contents
- 2. At a Glance
- 3. Main Features
- 4. Overview
- 5. How to Use the On/Off & Intensity Dial
- 6. The LED Indicator
- 7. Operating Modes
- 8. The Persistent Bark Indicator
- 9. Testing the YS600
- 10. Charging the Battery
- 11. Collar Fitting
- 12. Troubleshooting Guide
- 13. Warranty and Repair Information
Troubleshooting Guide
1. My dog is not reacting to the collar.
- Make sure the receiver/collar is turned on.
- Be sure the strap is on the dog tight enough so that both
contact points are touching the dog's skin.
- The contact points may be too short for your dog's thick or
long coat. To place an order for longer contact points, please
contact Dogtra or a Dogtra dealer. If you are already using
longer contact points, you may need to trim the hair on the
dog's neck, so that both contact points are touching the dog's skin.
- The intensity level may be too low for your dog. Increase the
stimulation until your dog responds.
2. My YS600 is not holding a charge.
- The charging pin may be damaged. A metal pin inside the
charging port should stand straight up and firm in the center. If
the pin is wobbly, broken or missing, you will need to send the
unit in to the repairs department.
- The charging port must be clean prior to charging, clean out
any dirt with a cotton swab and some rubbing alcohol. If your
dog was in salt-water, be sure to rinse the receiver and charging
port with clean water.
- For Dogtra units over two years old from the purchase
date, the batteries may need to be replaced. You can replace
them yourself by contacting Dogtra for a replacement
battery. Damages incurred to the unit due to improper battery
installations are not covered under the warranty. Dogtra
strongly recommends sending the unit in for inspection.
12