- ページ 5
マイクシステム Clockaudio CW 9000のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clockaudio CW 9000 11 ページ。 Uhf ppl wireless microphones
ページを印刷する4.2 CW9000T Hand held Transmitter/microphone
(i) To insert or change the battery
A. Remove the microphone head by unscrewing
counter-clockwise
B. Press both battery tray buttons towards each
other to release battery tray
C. Remove exhausted batteries and insert two
new AA batteries according to polarity
shown on tray
D. Push the battery tray carefully back in to the
microphone body until "clicked" home
E. Present the microphone head to the body
ensuring the connectors mate and resecure by
screwing clockwise
(ii) Switch the transmitter on using the On/Off switch
at the bottom of the microphone
(iii) To set the desired frequency press the "SET"
button for 3 seconds.
When "MHZ" blinks on the display the frequency
may be selected by using the "Up" and "Down"
buttons
(iv) Press the "SET" button to store the setting
(v) When signal is present AF (modulation) level
may be set.
Press the "SET" button twice. When "Sensit"
appears on the display use the "Up" and
"Down" buttons to adjust the right level
(vi) Press the "SET" button to store the setting
(vii) To prevent accidental operation of controls press
the "Up" button for 3 second to activate
the "Lock Mode".To unlock press the "Up"
button again
LCD display
A. Main display
B. Battery status indicator
C LO C K A U D I O
P A G E 8
SET
UP
DOWN
A
B
4.3 CW9001T Belt Pack Transmitter
(i) To insert or change the batteries
A. Press in and hold both outer cover release
buttons
B. Slide transmitter body downwards to expose
battery compartment in rear of body
C. Remove exhausted batteries and insert two
new AA batteries according to polarity shown on
tray
D. Push the transmitter carefully back in to
position until the release buttons click home
(ii) Insert the lavalier microphone connector in the
microphone socket on the top of the
transmitter
(iii) Switch on the transmitter using the On/Off
switch on top of the unit
(iv) Release the outer cover and slide transmitter
upwards to expose the display and controls at
the front of the transmitter
(v) To set the desired frequency press the "SET"
button for 3 seconds.
When "MHZ" blinks on the display the
frequency may be selected by using the "Up"
and "Down" buttons
ON/OFF
(vi) Press the "SET" button to store the setting.
(vii) When signal is present the AF (modulation) level
may be set by using a trimmer to adjust the
control set in the top left rear face of the unit
(viii) To prevent accidental changes to settings press
the "Up" button for 3 seconds to activate the
"Lock Mode".To unlock press the "Up" button
again
(ix) Push the transmitter carefully back in to position
LCD display
A. Main display
B. Battery Status indicator
MICROPHONE
SOCKET
ON/OFF
UP
SET
DOWN
AF LEVEL
A
B
C LO C K A U D I O
P A G E 9