- ページ 7

ペットケア製品 Dogtrace d-control easyのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dogtrace d-control easy 19 ページ。 Electronic training collar

INSTALLATION (REPLACEMENT) OF THE BATTERY IN THE REMOTE CONTROLLER

Remove the screw on the rear side of the remote controller and remove the battery compartment



lid from the controller carefully. Install a new CR2 3V battery and mind the correct polarity indicated

on the battery compartment lid. Replace the battery compartment lid and tighten the screw

adequately.

As the battery discharges, the performance (RF range) of your remote controller gets shorter.

It is necessary to replace the battery. You will recognize the weak battery according to a very weak

tone when your transmitter is turned on or off. Prepare a spare 3V lithium battery CR2 and follow the

previous section on Installation of the battery in the remote controller.

Make sure that the remote controller works correctly.

TIP: You can remove the batteries more

easily if you use a small screwdriver and

insert it carefully under the edge of the

battery.

Battery compartment