- ページ 7
録音機器 cymatic audio uTrack24 audiolanのPDF マニュアルをオンラインで閲覧またはダウンロードできます。cymatic audio uTrack24 audiolan 20 ページ。
cymatic audio uTrack24 audiolan にも： ユーザーマニュアル (18 ページ)
ページを印刷する
5. RECORDING
It is solely up to the audio signal connections to define whether a stacked or redundant multitrack recorder is formed.
The recording process is all the same, and only when importing the recordings to your PC using uTool you will
indicate which kind of recording you created.
The MASTER is setting up all SLAVES for sampling rate and bit depth. In addition, the recording take name is
negotiated between the devices to guarantee a unique and consistent take name.
Record:
The recording is started on the MASTER. While recording, use the MASTER buttons for control:
Prepare Rec:
In SYNC groups pre-recording is not available. Instead, use the new "Prepare Rec" parameter, available on the
MASTER, to set your system to instant recording (ON) or not (OFF). If set to ON, all devices in the SYNC group will
start the recording right at the click of the REC button. If the "Prepare Rec" parameter is set to OFF, it will take a few
seconds until the recording starts.
Note: Set "Prepare Rec" to ON in case you are mainly recording, in order not to miss the start of your take.
Stop:
The normal way to stop a recording is to press the STOP button on the MASTER. The STOP button on a SLAVE will
only stop the recording on this SLAVE unit and should only be used in emergency situations.
For example: If the MASTER's hard disk is full, the MASTER will stop recording. However, the SLAVES continue
recording (so at least these tracks are safe). In this (hopefully rare) situation, the only way to stop a SLAVE is
pressing its STOP button.
Warning: Synchronized playback is not guaranteed if a slave has been stopped manually.
Note: If the recordings have been stopped in an improper way, import the recording with uTool and export it again, in
order to avoid playback problems due to track length mismatch.
SYNC
RECORDING
7
uTrack24
Aug. 2016