- ページ 18

ペットケア製品 DogWatch BigLeash V-10のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。DogWatch BigLeash V-10 20 ページ。 Vibration trainer

Programming the Receiver Collar

Adding a Second Collar

Your transmitter is pre-set for use with one dog but can easily be programmed

for use with two dogs. Collar 2 has a red collar strap and has a small "Dog 2"

sticker on the back so that you can differentiate Collar 1 from Collar 2.

Before adding Collar 2 to the transmitter, charge it for at least 3 hours.

Make sure the transmitter and both the receivers (Collar 1 and Collar 2)

are turned 'off'.

With the transmitter and the receivers turned "off", hold down the ((V))

button for 10 seconds until the screen on the transmitter turns 'on'.

Set the

TRAINING LEVEL

Press and hold down the Collar 2 button while turning the new

receiver 'on' by aligning the receiver next to the transmitter at the

alignment markers.

Continue to hold the receiver next to the transmitter at the alignment

markers while holding down the Collar 2 button.

You will hear a series of beeps. When the series of beeps stops, move the

receiver away from the transmitter.

The second receiver is now programmed to the Collar 2 setting.

Turn the transmitter and receiver "on" in the usual way to use.

Re-Programming Collar 1 to the Transmitter

Follow the same steps as Adding a Second Collar, except:

Set the training level to '1' (step 4).

•

Hold down the ((V)) button instead of Collar 2 button (step 5).

•

to '2'.