- ページ 7
ペットケア製品 DogWatch Performance SeriesのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。DogWatch Performance Series 10 ページ。 Hidden fence systems
DogWatch Performance Series にも： オーナーズマニュアル (14 ページ), オーナーズマニュアル (16 ページ), オーナーズマニュアル (13 ページ)
ページを印刷する
!!YOU MUST COMPLETE THIS SECTION OTHERWISE YOUR UNIT WILL NOT WORK!!
SETTING THE RANGE
range the collar will not respond to the transmitter.
1.
The range of the signal field should be set for 3 – 8 feet (depending on the size of the
property and breed of dog). Confirm the actual distance by approaching the boundary wire
whilst holding the receiver collar with the test light. The collar will buzz and the test light will
come on at the edge of signal field. The range can be adjusted using the range adjuster on
the side of the transmitter box. This should be done before allowing your dog outside.
2.
Set rate to level 2 (if using a Performance Series System). Set mode to on (not applicable to
System 1200 transmitters or GroundsKeeper).
TRAINING
1. You must first set the collar to Audible only as laid out in the DogWatch handbook – Follow the
phases through starting with Phase 1 "Audible and "Beep" training.
To Set the collar to Audible only take the tester and place it between the locator points (the diagrams
below illustrate how to do this).
the levels and that is the correct way up (+ end down in the R12m and R7m and + up in the R12 & R9).
The collar will most likely beep twice when you place the tester in the locator points. Leave the tester in
place (the collar will beep through the levels) until you get to the long flat tone (this indicates Audible only
– beep no shock). Remove the tester when you hear the long tone and the collar will be set to audible
only.
– VIP All units are sent out with the range on zero – if you do not adjust the
See DogWatch Handbook.
Ensure
that you have inserted the battery in the collar before changing
Adjusting the training levels
on the R12 & R9 receivers
Adjusting the levels on the
R12m & R7m receivers