- ページ 8

ペットケア製品 DogWatch R8のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DogWatch R8 17 ページ。 Performance series transmitter and receivers

Setting The Transmitter: The Transmitter Rate switch adjusts to three settings:

(1 – slow, 2 – medium, 3 – fast). When your dog gets a correction, he receives it in a series

of pulses per second. Increasing the rate means that he will receive a greater number of

pulses per second. Rate 1 is the slowest pulse rate per second; 3 is the fastest.

Setting The Receiver: Both R7 and R8 Receivers provide six training levels that allow

you to customize the training setting to your dog's individual needs: Audible Only, Level

1(low), Level 2 (medium), Level 3 (medium high), Level 4 (high), and Level 5 (extra-

high). When the receiver is first turned on (from the manufacturer) it will automatically

be set to Training Level 2 (Medium).

Changing the R7 and R8 Receiver Settings

Your Dogwatch Dealer will start the training on the appropriate level according to your

dog's personality and traits. If you need to change the training level on the receiver,

hold your test light magnet to the two raised lines on the side of the receiver

(Figures

Hold the magnet steady and you will hear a series of beeps that indicate the

4 and 5.)

current (set) training level. The Training Level will continue to advance as long as the

magnet is held in position. For example, Level One is one beep, Level 2 is two beeps,

etc. The beeps (or Receiver Tones) represent the Training Level the receiver is set at.

See Chart on Page 8

Figure 4: R7 Receiver Settings

Figure 5: R8 Receiver Settings

When you reach the desired training level setting, pull the magnet away from the

receiver. The receiver is now set. Note: Any time the magnet activates the receiver, it

will first tell you what level the receiver is set to and as long as the magnet is held in

place, it will advance the receiver to the next training level and continue to cycle

through the settings in the order shown in the chart on Page 8.

™ Correction:

UTO

EMORY

The R7 and R8 Receivers includes an A

™ feature on training levels 2, 3 and

UTO

EMORY

4. When the correction level is set to any of these three settings, and the dog challenges

the boundary, the A

feature will enable as the dog leaves the audible zone

UTO

EMORY

and returns to the Safety Zone. The receiver will then advance to the next highest

"Receiver Training Level". The "rate" will remain in the existing "1, 2, 3 setting but will

jump to the next level per the chart on the page 8. If the dog challenges the boundary

again within 24 hours, he will receive that next highest correction level. The receiver will

not advance to any higher level.