- ページ 5
ペットケア製品 DogWatch System 1200のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DogWatch System 1200 16 ページ。 System
DogWatch System 1200 にも： インストレーション・マニュアル (10 ページ), オーナーズマニュアル (12 ページ), 取扱説明書 (9 ページ)
ページを印刷する
Setting and Changing the Training Level
R12 Receiver
Hold the magnet between the two lines on the
side of the receiver to reset the training level.
When you reach the desired Training Level, pull the magnet away from the receiver. The
receiver is now set. Note: Any time the magnet activates the receiver, it will advance the
receiver setting to the next Training Level, and continue to cycle through the settings in
the order shown in the table below, as long as the magnet is held in place.
: Any magnet directed at the marks on the side of the receiver will activate this process.
NOTE
Training Level
Tone
Correction
Level
Multiple Dogs The System 1200 allows you to select a different training level for each
dog – allowing you to conduct training with one dog, for example on Level 1, while the
other dog is protected with Level 2.
Receiver Status Light
The status light continuously monitors your receiver and provides these features.
• Start-Up When you first insert the battery into your
receiver, the status light will flash
indicates that the receiver has started properly. Once
started, the status light will continue to flash
once every 40 seconds indicating normal operation.
In the event that the light does not flash, check the
battery to be sure that it has been inserted properly.
• Training Level Indicator When programming the
training level of your receiver (see page 8), the status
light will flash
green
beeps. The number of flashes/beeps will equal the
training level you have chosen.
• Signal Field Indicator When testing the receiver in
the signal field, the status light will flash
the receiver is in the audible zone and will flash
and
green
when the receiver is in the correction zone.
(cont. next page)
Audible Only
One Long Beep
None
red
in conjunction with audible
(cont.)
R12m Receiver
Hold the magnet at the marked area on the
side of the receiver to reset the training level.
Level 1
Level 2
1 beep
2 beeps
Low
Medium
and green. This
green
green
when
red
- 3 -
Level 3
Level 4
3 beeps
4 beeps
Medium
High
-High
The R 12m Status Light
The R12 Status Light