- ページ 3

室内装飾品 Aseptico ADC-02のPDF 取扱説明書&パーツリストをオンラインで閲覧またはダウンロードできます。Aseptico ADC-02 16 ページ。 Portable hydraulic dental chair

Aseptico ADC-02 取扱説明書&パーツリスト

SETUP AND OPERATION

1
UNPACKING:
Using
people, lift the chair
A
the shipping box and set it on
the floor.
2
MOVING INTO POSITION:
A
Pull out the stabilizer
use it as a handle to tilt the
chair up onto its wheels B,
then roll the chair to where it
will be used.
WARNING: The backrest
C
strap
must always be
securely
fastened
when
tilting the chair upright to
prevent injury or damage
caused by the backrest
suddenly opening.
3
CHAIR PREPARATION: Set the chair down with its feet on the
floor. Make sure that the stabilizer
B
the leveling foot
as needed to compensate for an uneven
floor. Remove the backrest strap
reuse.
C
A
WARNING: The stabilizer must be fully extended and the
leveling foot properly adjusted to reduce chair tipping hazard.
The floor under the chair must be hard and level.
two
from
A
A
and
B
A
is fully extended. Adjust
C
from the chair and save for
ADC-02
4
SELECTOR LEVER LABELS: Locate the 2 selector lever labels
A
on opposite sides of the chair base. These labels show the
selector lever positions for lifting and lowering the seat and
the backrest.
L O W E R
The selector lever can be operated hands-free from either side
of the chair.
5
SEAT LIFT: Rotate the selector lever
tion (as shown on the label B) then pump the lift lever
your foot until the chair reaches the desired height.
C
6
SEAT LOWER: Press down and
hold the selector lever
the SEAT LOWER position (as
shown on the label B) to lower
the chair.
B

EXTENDING THE SELECTOR LEVERS

The selector levers can be extended outward to make them easier to
The selector levers can be extended outward to make them easier to
reach. Depress the locking button
reach. Depress the locking button
slide the selector lever out until the locking button pops out of the
slide the selector lever out until the locking button pops out of the
B
second hole
second hole
A
A
to the SEAT LIFT posi‑
B
A
A
in
A
on the selector lever tube, then
on the selector lever tube, then
on the tube.
on the tube.
A
B
L O W E R
C
with
C
B
A
3