- ページ 11

水族館 DOHSE AQUARISTIK HOBBY pH-Control ecoのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DOHSE AQUARISTIK HOBBY pH-Control eco 16 ページ。

When this value has settled, press the

the LED light flashes one time as confirmation of acceptance. Then

displayed for one second.

flashes. Take the elctrode out of the pH 7 solution and press

proceed calibration.

5. Rinse the electrode tip briefly with destilled water.

6. To calibrate the pH Electrode for freshwater aquaria, dip the electrode into

the pH 4 solution for freshwater and acknowledge with

(To calibrate the pH Electrode for saltwater aquaria, use the  or  button

until

flashes, dip the electrode into the pH 9 solution for saltwater and

acknowledge with

Then a measured running value is displayed.

7. When this value has settled, press the

the LED light flashes one time as confirmation of acceptance. The calibration

is finished.

8. Rinse the electrode tip briefly with HOBBYdest.

9. Fix the electrode in the aquarium with suction cups.

Please note: The calibration can be interrupted at any time by pressing

the  or  button at the same time.

Caution: Used electrodes which top has been dried completly in the

protection cover need to be put in water over night before the

calibration is done. New electrodes need a 14 days run-in period.

After that a second calibration is necessary for precise mesurement.

When finished,

and

are flashing.

button for three seconds – until

button for three seconds until