ページを印刷するASGGLASHELF###
FIT ALL WOOD FLOORING PRIOR TO FITTING SHELVES.
2
4
3
FIG 5
SHOWS THE CENTRAL JOINT WHERE SHELVES
ARE BEING FITTED SIDE BY SIDE.
THE SCREWS FITTING THESE BRKTS SHOULD BE
FITTED THROUGH THE BACK HOLES 'A'
(THIS APPLIES ON THE EXTENSION JOINTS ALSO)
THE FRONT AND REAR SHELF BRKTS ARE
FITTED USING THE FRONT FIXING HOLES 'B'
PACK CONTENTS:
PART
LH SHELF BRKT
RH SHELF BRKT
GLADIATOR SHELF
M5*12BHD SCREW
ASGARD GLADIATOR SHELF FITTING INSTRUCTIONS
STEP 1
(SHELF SHOWN FROM UNDERSIDE)
FIT LH AND RH SHELF BRKTS AS SHOWN
USING THE SCREWS SUPPLIED, SCREWING
INTO THE THREADED INSERTS.
LEAVE THE SCREWS SLACK TO ENABLE
THE SHELVES TO BE ADJUSTED ONCE IN
POSITION IN THE UNIT.
2
3
QTY
1
2
2
2
3
2
4
8
STEP 2
THE SHELF IS FIXED UTILISING THE SCREWS
ALREADY IN THE UNIT.
POSITION THE PRE-ASSEMBLED SHELF AT THE DESIRED
HEIGHT ALIGNING THE CLEARENCE HOLES IN THE SHELF
BRKTS WITH THE CORRESPONDING SCREWS. (TWO PER BRKT)
REMOVE THE SCREWS AS REQUIRED AND REFIT FIXING THE
SHELF BRKTS IN PLACE. (SEE FIG 5 BELOW)
WHEN SHELVES ARE FITTED TIGHTEN
MACHINE SCREWS '4' TO SECURE.
1
1
A
B
FIG 5
1
A
B
3
3
SHELVES ARE SHOWN FITTED SIDE BY SIDE IN
THE LH SIDE OF A GLADIATOR. (THEY CAN BE FITTED
IN BOTH SIDES OF THE UNIT) AND ALSO IN THE
EXTENSION SIDE PANELS
SHELVES CAN ALSO BE FITTED ONE ABOVE THE
OTHER UP TO THREE HIGH.