- ページ 12

デジタル・プレゼンター Ash Technologies EclipseのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Ash Technologies Eclipse 15 ページ。

Focus button is pressed or when the zoom level is altered. If the height

of the material under the camera is changed, it will be necessary to

press the focus button again.

Manual Focus: This mode is useful if you require an image that is

slightly out of focus or you are looking at an awkward object that

the camera will not focus on correctly. In this mode you must press

(Hold focus button down and press Zoom Up or Down) to

set your desired focus.

6C. Factory Defaults

Selecting this menu item will restore all video settings, modes,

colours and button functions to their factory settings. This option is

provided in case you set the unit into a mode that you cannot remember

how to undo. You will be prompted to press the middle function button

on the front panel to reset the unit;

pressing any other button will exit

without altering the current settings.

The internal firmware revision is displayed on the top line. Generally, it

is of no concern.

If, for some reason, you cannot see the menu to choose Factory

Defaults then perform the following sequence of button presses:

• Power the unit off then on again. Wait for a few seconds to allow the

start-up sequence to complete.

• Press and hold the mode button

• Press Zoom-Up once.

• Press Focus once.

• Press the middle function button and the factory defaults should be

restored.

PRESS X TO RESET

until the beep is heard.

Page 12

Rev 1.01

Rev E US EN