- ページ 4

楽器アンプ Ashdown MARK KING MK500のPDF 操作説明をオンラインで閲覧またはダウンロードできます。Ashdown MARK KING MK500 4 ページ。 Mark king signature series bass amplifier

ページを印刷する

O perating I nstructio ns

This is to carry the signal to the P.A. system for larger gigs. It is balanced and low impedance to ensure that

no noise is added to the signal on the way to the mixer.The level of this signal has been set to be similar

to that from a microphone so that it will work without overloading the input on a desk that has no input

Pad switch.

The signal connections are as follows: Pin 1 = Ground, Pin 2 = Signal +, Pin 3 = Signal -.

The DI signal can be switched to be PRE or POST EQ. PRE EQ is before any of the amplifier's facilities or

EQ but after the INPUT GAIN control. POST EQ is after all internal facilities and includes the external

effects loop.

MUTE/TUNE

The front panel MUTE switch provides a mute facility that can be used to silence all outputs from the

amplifier except that from the TUNER output socket.This enables silent tuning to be carried out whilst the

amplifier speaker outputs, the DI the Effects Send and the Line Output are all muted. Once in tune the

amplifier can be un-muted and playing resumed.This switch can also be used as a STANDBY switch for

silencing the amplifier during pauses in its use. A blue LED below this switch will illuminate to indicate

when the amplifier is Muted.

To make use of the Tuning facility plug the output from the TUNER socket into the INSTRUMENT input on

your tuner.

OUTPUT LEVEL

The OUTPUT LEVEL control is used to set the stage volume of the amplifier. Use this control to adjust for

increases or decreases in your playing volume and not the INPUT GAIN control, this should always be left

set to the optimum for your instrument.

LINE OUTPUT

The LINE output is for connection to external power amplifiers and speakers to allow you to build a larger

more powerful system.This output is situated after the OUTPUT LEVEL control to allow the entire

connected system to be turned up and down with a single control.

If you require a line output that is not affected by the OUTPUT LEVEL control you may use the EFFECTS

SEND jack socket, this will obviously not include any effects loop signal.

REAR PANEL FACILITIES

EFFECTS SEND/RETURN

A serial effects loop is provided at a level of 0dB.

The EFFECTS SEND socket can also be used as a

Line Out socket if required as the signal path

through the preamp is only broken when a jack plug

is inserted into the EFFECTS RETURN socket.

The EFFECTS SEND is situated after the EQ.

SPEAKER OUTPUT

The Speaker Output sockets are also situated on the rear panel of the unit and are provided on both Jack

& Speakon connectors.

Specificatio ns

INPUTS

Jack Input

Impedance - 3.9M Ohms

XLR Input

Balanced - 600 Ohms

Effects Return

Impedance - 10K Ohms

OUTPUTS

Tuner Output

Impedance - 22K Ohms

Line Output

Impedance - 1K Ohms

Effects Send

Impedance - 22K Ohms

D.I. Output

Impedance - 600 Ohms Balanced

EQUALISATION

Graphic Equalisation

+/- 15dB @ 12 centre Frequencies

Speaker Outputs

Min Impedance - 4 Ohms

Frequency response

-3dB at 17Hz and 30kHz

Input Range 150mV to 20V p - p

Input Range 100mV to 10V p - p

Input Level 0dBu Nominal

Level 0dBu Nominal

Level -20dBu Nominal

500 Watts RMS 1000 Watts Peak