ページを印刷する
M6 x 70 Cup
Head Bolt
M6 x 16
Washer
M6 Hex
Nut
14. Slide 5 treadles J onto the long steel rod with a round wooden
spacers k between. Add the centre block. Then add the next 5
treadles and round wooden spacers followed by the treadle blocks l
at either end. Note that the rod holes in the treadle blocks must be
towards the top. Then bolt all 3 blocks to BX with
,
and
Bolt
M6 X 16 Washer,
15. Tap a
M6 x 50 Cup Head Bolt
the inside of back upright CX and then
attach spacer P through the hole with
a
and nylon knob. Note
M6 x 22 Washer
the middle slot is used to hold the back
beam in the closed position. Repeat for
the other side.
16. Tap a
M6 x 50 Cup Head Bolt
inside of castle side EX. Locate the slot
in spacer P onto the
bolt
with a
and nylon knob.
M6 x 22 Washer
Repeat for the other side.
Steel Rod
M6 x 70 Cup Head
M6 Hex Nut.
through
M6 x 50 Cup
Head Bolt
TAP IN WITH
through the
and secure
M6 x 70 Cup
Head Bolt
M6 x 22
Washer
HAMMER
10
M6 x 70 Cup
Head Bolt
M6 x 70 Cup
Head Bolt
Nylon Knob
M6 x 50 Cup
Head Bolt
M6 x 16
Washer
M6 Hex
Nut
M6 x 22
Nylon Knob
Washer