- ページ 2

電動工具 Ashford FREEDOM FLYERのPDF 使用方法をオンラインで閲覧またはダウンロードできます。Ashford FREEDOM FLYER 2 ページ。 For single & double treadle joy spinning wheels

ページを印刷する

If your new Sliding Hook Flyer does not

thread easily or fully into the top shaft, your

wheel was probably made before 2002.

Enclosed is a new top shaft and instructions

on how to fit it.

Tools required

Screwdriver, small hammer, pliers and eye

protection.

Before commencing and to avoid frustration

please read these instructions carefully and

follow the step by step instructions in the

correct sequence.

1. Remove the two back E-Clips from top

shaft and crank.

Caution: the E-Clips are under tension and

can fly off. Wear eye protection.

2. Remove the four screws that retain the

back frame to the four dowel spacers.

3. Remove the three screws that attach the

back frame to the base.

Ashford Handicrafts Limited

Factory and Showroom: 415 West Street

PO Box 474, Ashburton, 7700 New Zealand

Telephone 64 3 308 9087 Facsimile 64 3 308 8664

Email: [email protected] Internet: www.ashford.co.nz

INSTRUCTIONS

REPLACING THE TOP SHAFT

JOY ASHFORD SPINNING WHEEL

4. Use a hammer and nail to tap the flyer

shaft and crank forward until they are free of

the bearings in the back frame.

5. Lift the back frame away from the flyer

shaft and crank.

6. Carefully remove the E-Clip from the front

of the flyer shaft and slide the shaft out.

Carefully remove the E-Clip from in front of

the pulley and slide the pulley off the shaft.

Tap the tension pin out of the original flyer

shaft and tap it into the new flyer shaft. Slide

the pulley onto the new flyer shaft until the

groove engages the tension pin. Then secure

with an E-Clip. Fit the new shaft into the

frame and secure with an E-Clip.

7. Place the drive belt around the wheel and

pulley. Then replace the back frame into posi-

tion carefully sliding the flyer and crank back

through the ball bearings. Note: Take care not

to push the ball bearings out of the plastic

bearing housings.

8. Replace the E-Clips onto the grooves in the

flyer shaft and crank. Wear eye protection.

Ensure the E-Clips locate into the bottom of

the grooves. It may be necessary to squeeze

the front and back frame together to ensure

the crank projects through the bearing.

9. Replace the screws holding the back frame

to the base and dowel spacers.

10. Thread the flyer into the shaft.

Ashford Guarantee

Thank you for purchasing this Ashford product. In the unlikely event there is any

fault in manufacture we will replace the item. To validate our guarantee please

visit our website or write to us.

E-Clip

You are now ready to spin.

01052014V3