- ページ 10

アンプ Cloud 36-50 MULTI-ZONEのPDF インストレーション＆オペレーションマニュアルをオンラインで閲覧またはダウンロードできます。Cloud 36-50 MULTI-ZONE 14 ページ。 36/50 2 zone integrated mixer amplifier

36/50: Installation and Operation Manual

When setting the jumper(s) please ensure that you:

• Remove the mains cable from the rear of the product before removing the top panel.

• Only reassemble the unit using bolts/screws identical to the original parts.

Controlling two zones with one RSL-6

A single RSL-6 can be used to control more than one zone; however, the five resistors fitted

to the RSL-6 will have to be replaced with different values. Where a single RSL-6 is used to

control two zones, the resistors R1, R2, R3, R4 & R5 should be removed and replaced with

the following values:

Where two zones are controlled by one remote plate, the level control will be loaded by the

additional circuitry and will operate with a non-linear range; however, this has proved to be of

little consequence operationally.

Controlling two zones with one RL-1

A single RL-1 can be used to control the music level of more than one zone, however, the

extra load can cause compression of the potentiometer law resulting in a non-linear control;

this has proved to be of little consequence operationally.

The 36/50 can be used as part of an automated sound system by controlling the music level

and music source by an external 0-10V DC voltage. The 3-pole connector normally used to

terminate the RSL-6 can be used to feed two separate control voltages into the unit. Pin 1 is

a ground (0V) termination common to both control voltages; this should be connected to the

technical ground (0V) of the voltage source. Pin 2 is the control voltage input for the music

level and pin 3 is used to control the music signal source selection.

06/12/02 V5.0

A Single RSL-6 wired to Control Two Zones Simultaneously

A Single RL-1 wired to Control Two Zones Simultaneously

2k7

1k3

1k1

910R