- ページ 12

マザーボード Cypress CY8CKIT-002のPDF キットマニュアルをオンラインで閲覧またはダウンロードできます。Cypress CY8CKIT-002 16 ページ。 Psoc miniprog3 program and debug kit guide

3.1.5

RX8

UART is another common serial interface standard. MiniProg3 uses UART (RX8), which allows the

tool to receive the data from UART (TX8)-enabled devices on the target board. Refer to the "RX8

Example (MiniProg3)" section in the Bridge Control Panel Help document for more details.

3.1.6

For more information on the PSoC 3, PSoC 4, PSoC 5LP, and PSoC 6 JTAG, SWD, and I

interfaces, see the

more information on PSoC 1 interfaces, see the

3.2

3.2.1

The 5-pin connector is configured as a single row with a 100-mil pitch. It is designed to mate with a

Molex model 22-23-2051 (straight) or 22-05-3051 (right angle) male header with a key tab.

Figure 3-2. 5-Pin Connector with Pin Assignments

MiniProg3

(End View)

3.2.2

10-Pin Connector

The 10-pin connector is configured as a dual row with 50-mil pitch. It is used with a ribbon cable

(provided) to mate to a similar connector on the target board. The recommended mating connectors

are the Samtec FTSH-105-01-L-DV-K (surface mount) and the FTSH-105-01-L-D-K (through hole)

or similar connectors available from other vendors. The signal assignment is shown in

When programming JTAG devices, note that MiniProg3 does not support nTRST pins.

CY8CKIT-002 PSoC® MiniProg3 Program and Debug Kit Guide, Doc. # 001-59350 Rev. *I

PSoC 3, PSoC 4, PSoC 5LP, and PSoC 6 Technical Reference

SDAT

SCLK

XRES

GND

VTARG

Mating

Connector

PSoC 1 Technical Reference

Technical Description

Manuals. For

Manual.

Figure

3-3.