- ページ 2
マザーボード Cypress CYUSB3ACC-004AのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cypress CYUSB3ACC-004A 2 ページ。 Interconnect board for on semiconductor image sensor
ページを印刷する
CYUSB3ACC 004A INTERCONNECT BOARD FOR
ON SEMICONDUCTOR IMAGE SENSOR QUICK START GUIDE
3. Set the Jumpers on the boards as shown below
ON Semiconductor Image Sensor Board
(MT9M114_55CSP_HB_DEMO3_REV0)
Jumper/
Jumper/
Header No.
Header Name
P1
OE_L
P2
CONFIG
P4
FLASH
P5
TRST
SADDR
P6
P7
+VDDIO
P8
UART
EEPROM
P11
P15
I2C connector
P32
CLOCK SELECTION
4. Learn to use FX3 in applications involving image sensors with the
application note
with EZ-USB
FX3
®
www.cypress.com/AN75779.
to stream video from the Image Sensor to a PC using FX3
For the latest information about this interconnect board and to download the
hardware les, visit
For the latest information about EZ-USB FX3 SuperSpeed Explorer Kit
(CYUSB3KIT-003) and to download Kit Software and Hardware les,
visit
www.cypress.com/SuperSpeedExplorerKit
© 2019 Cypress Semiconductor Corporation. All rights reserved.
All trademarks or registered trademarks referenced herein are the
properties of their respective owners. Doc.#: 002-26891 Rev **
Jumper Setting
1-2
2-3
Open
1-2
1-2
2−3
Open
Closed (A1 column)
1−2 & 3−4
3−5 & 1−2
AN75779 - How to Implement an Image Sensor Interface
in a USB Video Class (UVC) Framework
TM
Refer to sections 6 to 8 for the instructions
www.cypress.com/CYUSB3ACC-004A
Cypress EZ-USB FX3 Superspeed
Explorer Kit (CYUSB3KIT-003)
Jumper/
Header No.
J2
J3
VBUS_JUMPER
J4
J5
SRAM_ENABLE
available at
Note:
Please take care when removing the
interconnect board from the SuperSpeed
Explorer Kit board
The suggested removal method is
shown in the picture. Hold the
interconnect board and use a rocking
motion to separate the boards safely
Jumper/
Jumper
Header Name
Setting
VIO1_3
Closed
Closed
PMODE
Closed
Open