- ページ 9

アンプ Ashly KLR 4000のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Ashly KLR 4000 12 ページ。 Klr series two-channel, high-performance power amplifiers
Ashly KLR 4000 にも：仕様 (2 ページ)

ページを印刷する

Operator Manual – KLR Series Amplifiers

Speaker Connections

Stereo Speaker Wiring

In this mode, the amplifier's channels operate fully independent of each other. Each signal

enters the unit and is amplified separately and wired using different connectors.

Stereo Speaker Wiring Using Single 4-Conductor Speaker Cable

In this mode, the amplifier's channels still operate independent of each other. Each signal is

amplified separately, however both channels are wired using the Channel 1 connector.

Bridged (Mono) Mode

In this mode, a single input is connected to channel 1 and is connected to the two output

channels that have been "Bridged" together using the Channel 1 connector. Minimum

Bridged load impedance is 4Ω.

(

Note: KLR 5000 speaker outputs not shown – see page 5

Page - 9

Important Safety

)

Instructions – 2

Introduction - 3

The KLR Series - 4

Physical Description - 5

Installation – 6

Requirements

Installation Density

Typical Applications

Connectors & Polarity

Speaker Connections

Troubleshooting - 10

Spec Table - 11

Warranty - 12

0611