- ページ 10

アンプ Ashly PE SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Ashly PE Series 13 ページ。 Pe-series amplifier
Ashly PE Series にも: 取扱説明書 (13 ページ)

Ashly PE Series 取扱説明書
Page - 10
Operator Manual – PE Series Amplifiers
Introduction - 2
Measurements
The PE Series - 3
Physical Description - 4
The following graphs are actual measurements from PE-Series amplifiers during typical use.
Installation – 5
Operation – 7
Troubleshooting - 8
Spec Table - 9
Measurements - 10
Dimensions - 11
Gain vs. frequency, Ch1, Ch2 - (typical performance)
Gain vs. frequency / positions of HPF, Ch1, Ch2
Warranty - 12
Phase vs. frequency, Ch1, Ch2
Phase vs. frequency / positions of HPF-Switch, Ch1, Ch2
Output impedance vs. frequency @ 1 Amp RMS injected current
THD+N @ 1 kHz, 8 Ω load vs. input voltage, Ch1, Ch2
(Ch1, Ch2) equivalent 11 mΩ + 2,1 µH
Damping factor into 8 Ω, Ch1, Ch2 equation: damping factor = loaded
THD+N vs. frequency (BW 22 kHz),
impedance / amplifier output impedance
10 dB below clip, 8Ω, Ch1, Ch2
CCIF difference frequency method (10,5 kHz and 11,5 kHz) vs. input
SMPTE intermodulation distortion (60 Hz and 7 kHz)
level @ 8 Ω, Ch1, Ch2
@ 8 Ω vs. input level, Ch1, Ch2
Common mode rejection ratio (Ch1, Ch2)
Channel separation vs. frequency
@ 10 W / 8 Ω (Ch1 => Ch2, Ch2 => Ch1)
Copyright© 2005 – Ashly Audio Inc.