- ページ 8

アンプ Ashly SRA-2075のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Ashly SRA-2075 12 ページ。 Sra series standard power amplifiers
Ashly SRA-2075 にも: 取扱説明書 (12 ページ), パンフレット&スペック (4 ページ), 仕様書 (2 ページ), 仕様書 (2 ページ)

Ashly SRA-2075 取扱説明書
Page - 8
Important Safety
Instructions – 2
Operation
Introduction - 3
The amplifier's On/Off Switch is a rocker-type switch located on the left side of the front
The SRA Series - 4
panel. Turning on the amplifier initiates start-up by activating the inrush current limiter.
Physical Description - 5
When using the remote On/Off function, the main On/Off switch must remain in the On
Installation – 6
position. See page 11 for more information on remote On/Off connections.
Operation – 8
2 Channel Mode
Bridged Mode
NOTE: The power switch does NOT isolate the appliance from mains. Make sure the mains
power socket or an alternative disconnect device is near by and easily accessible. When the
Troubleshooting - 9
product is connected to mains, the line-filter and the input of the fuse are energized.
Spec Table - 10
Dimensions - 11
Warranty - 12
2 Channel (Stereo) Mode
In this mode, the amplifier's channels operate fully independent of each other. Each signal
enters the unit and is amplified separately.
Bridged (Mono) Mode
In this mode, a single input is connected to channel 1 (or 1 & 3 in 4 channel models) and is
connected to the two output channels that have been "Bridged" together.
Each output channel processes the signal, but the polarity of channel 2 (and channel 4, in 4
channel models) is reversed. The (single) load is connected between the two positive
channel outputs. While the total output of the amplifier remains the same, both the
available output voltage and the minimum impedance that can be connected are doubled,
as compared with stereo operation.
Only Channel 1 (or 1 & 3) is active. A signal feeding Channel 2 (or 4) will have no effect
on the output.
Operator Manual – SRA Series Amplifiers
Copyright© 2010 – Ashly Audio Inc.